Wireless Radiator Valve (C) Relearn
- Simon Turner
This article is an excerpt from the Genius Hub Doctor, which is built into the App.
These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.
To access the Doctor, click here
Solution ID: 7464
Step 1
Sometimes a Genius Radiator Valve may lose the factory settings which were applied to it when it was added to the system. This can occur when the batteries have been changed in the device. When the Genius Radiator Valve has the incorrect configuration messages it can communicate with the Genius Hub too often, which leads to the batteries not lasting as long. For the Genius Radiator Valve (with the 'G' on the top as in the image below), this can also cause it to not report back the calculated temperature to the Genius Hub. When the device is reconfigured the wake-up interval is reset back to 7 minutes 30 seconds.
Step 2
First locate the radiator valve in the room you want to adjust.
The Doctor will ask you to select the relevant device
Step 3
The device now needs to be redetected by the Genius Hub to ensure the correct behaviour and communication.
The Doctor will communicate with the device
Step 4
Wake up the device by short pressing one of the arrow buttons once.
Any remaining issues with the Genius Radiator Valve will now be displayed below.
Issue details
Wait for the message counter in the top box to disappear, and it to say 'Got Device Data'. If there are still errors above in the list at this point, the device will need troubleshooting once again. The message queue may take a couple minutes to empty.