Electric Relay Reinclude
- Simon Turner
This article is an excerpt from the Genius Hub Doctor, which is built into the App.
These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.
To access the Doctor, click here
Solution ID: 7351
Step 1
Install the Electric Relay as per the Wiring diagrams .
To add the device, ideally this is within direct range of the Genius Hub (either in the same room as each other, or adjacent rooms).
If the devices are not close enough together:1. Move the Genius Hub closer to the Electric Relay. The Genius Hub must have power and an Internet connection. This can be done by:
a) Using a long Ethernet cable
b) Plugging the Hub into a different Ethernet switch
c) Using a Power Line Ethernet adaptor or WiFi booster which has an Ethernet port (
see this link for how to connect the hub with a power-line Ethernet adaptor
)
2. Temporarily wire the Electric Relay to a plug and short piece of flex so you can power on the Electric Relay next to the Genius Hub. It is recommended that this is done by an electrician/heating engineer.
Step 2
Now the Genius Hub needs to get ready to add the device.
The Doctor will search for the new device
Step 3
Press the button on the Electric Relay 3 times in 1.5 seconds.
The red light stops flashing when the device has included successfully. If the red light continues to flash, unplug and re-plug in the device.
On success, the Electric Relay has been assigned a number, write this number on the front/side of the device.
If you have excluded or factory reset the device previously, it will re-add with a new, different number. If it has the same number as before the reset, the device was not successfully excluded/factory reset.
The Doctor will communicate with the device
Step 4
First locate the Electric Relay which has been re-added Genius Hub. You need to use the original ID number of the device, and not the one which it currently has.
The Doctor will ask you to select the relevant device
Step 5
First the Genius Hub needs to attempt to communicate with the Electric Relay once more. This is to ensure that the device is a 'dead node' and so is eligible to be removed from the system in this way.
The Doctor will communicate with the device
Wake the Electric Relay by pressing the button once.
Step 6
Now the device is confirmed as no longer on the system, it can be removed.
The Doctor will attempt to remove the device