This article is an excerpt from the Genius Hub Doctor, which is built into the App.

These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.

To access the Doctor, click here

Solution ID: 7350

Step 1

Install the Electric Relay as per the Wiring diagrams .

To add the device, ideally this is within direct range of the Genius Hub (either in the same room as each other, or adjacent rooms).

If the devices are not close enough together:

1. Move the Genius Hub closer to the Electric Relay. The Genius Hub must have power and an Internet connection. This can be done by:

a) Using a long Ethernet cable
b) Plugging the Hub into a different Ethernet switch
c) Using a Power Line Ethernet adaptor or WiFi booster which has an Ethernet port ( see this link for how to connect the hub with a power-line Ethernet adaptor )

2. Temporarily wire the Electric Relay to a plug and short piece of flex so you can power on the Electric Relay next to the Genius Hub. It is recommended that this is done by an electrician/heating engineer.

Step 2

Now the Genius Hub needs to get ready to add the device.

The Doctor will search for the new device

Step 3

Press the button on the front of the Electric Relay 3 times in 1.5 seconds, the red LED behind to the button will start to flash quickly.

The flashing red light turns off when the device has included successfully. If the red light continues to flash, unplug and re-plug in the device.

On success, the Electric Relay has been assigned a number, write this number on the side of the device.

The Doctor will communicate with the device

Step 4

Now pick a zone to assign the Electric Relay to.

The Doctor will ask you to select a zone

Step 5

The Doctor will create the new zone

Step 6

The Doctor will now assign the device to a zone

Step 7

This device has now been added to your system.

Browser not supported