In Wall Meter Include
- Simon Turner
This article is an excerpt from the Genius Hub Doctor, which is built into the App.
These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.
To access the Doctor, click here
Solution ID: 7300
Step 1
Install the Range Extender as per the Wiring diagrams .
To add the device, ideally this is within direct range of the Genius Hub (either in the same room as each other, or adjacent rooms).
If the devices are not close enough together:1. Move the Genius Hub closer to the Range Extender. The Genius Hub must have power and an Internet connection. This can be done by:
a) Using a long Ethernet cable
b) Plugging the Hub into a different Ethernet switch
c) Using a Power Line Ethernet adaptor or WiFi booster which has an Ethernet port (
see this link for how to connect the hub with a power-line Ethernet adaptor
)
2. Temporarily wire the Range Extender to a plug and short piece of flex so you can power on the Range Extender next to the Genius Hub. It is recommended that this is done by an electrician/heating engineer.
Step 2
Now the Genius Hub needs to get ready to add the device.
The Doctor will search for the new device
Step 3
Press the button on the Range Extender 3 times in 1.5 seconds.
The red light stops flashing when the device has included successfully. If the red light continues to flash, unplug and re-plug in the device.
On success, the Range Extender has been assigned a number, write this number on the front/side of the device.
The Doctor will communicate with the device