Wireless Room Sensor Factory Reset

Owned by Simon Turner
Sept 16, 2024
1 min read

This article is an excerpt from the Genius Hub Doctor, which is built into the App.

These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.

To access the Doctor, click here

Solution ID: 7554

Step 1

Factory resetting a device removes it from any Genius Hub and removes any custom settings. It does not require a Genius Hub to power powered on/in communications range.

Ensure that the Wireless Room Sensor has working batteries installed.


Step 2

Remove the front cover of the Wireless Room Sensor by placing a tool (such as a flat-bladed screwdriver) into the top of the sensor until you hear a click.

This will release the catch. Pull the white (front) of the room sensor away from the clear (back) and allow the cover to swing down (be careful not to pull the sensor off the wall). The front is hinged at the bottom.


Step 3

Press the small switch at the top left of the circuit board 4 times within 1.5 seconds, and on the last press keep the switch pressed down.

The red LED will illuminate and then extinguish.

As soon as the LED turns off, release the button.

If the Wireless Room Sensor has been successfully reset the light will flash slowly.

Click here to add the Wireless Room Sensor to this Genius Hub