Wireless Room Thermostat (B) Include

Owned by Simon Turner
Sept 16, 2024
2 min read

This article is an excerpt from the Genius Hub Doctor, which is built into the App.

These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.

To access the Doctor, click here

Solution ID: 7650

Step 1

The the Wireless Room Thermostat to the same room as the Genius Hub.

Remove the thermostat from its backplate by loosening the two screws at the bottom of the backplate.

Ensure there are new batteries in the Room Thermostat.

Turn the thermostat over, so the dial is facing away from you and put the number 1 dip switch (left side) into the UP (on) position.


Step 2

Now the Genius Hub needs to get ready to add the device.

The Doctor will search for the new device


Step 3

Turn the thermostat back over so the dial is facing you.

Rotate the dial until 'L' is on the screen and press the dial, as a button. 'L' will start to flash.

After 10 seconds the screen shows 'LP' when the device has included successfully.

If 'LP' is not displayed this is not a problem so long as a number for the device is included successfully in the status box below.

On success, the Room Thermostat has been assigned a number, write this number on the side of the device.

The Doctor will communicate with the device


Step 4

Turn the thermostat over, so the dial is facing away from you and put the number 1 dip switch into the DOWN (off) position.


Step 5

Now pick a zone to assign the Room Thermostat to.

The Doctor will ask you to select a zone


Step 6

The Doctor will create the new zone



Step 7

The Doctor will now assign the device to a zone



Step 8

Attach the Room Thermostat to a wall in the coldest room of the house if controlling the main source of heating, or attach it in the room that you want to control if controlling an individual zone.

First screw the backplate to the wall in the chosen room. Then fit the Room Thermostat onto the backplate by locating the pegs at the top corners of the backplate to the recesses in the back of the Room Thermostat, then hinging the Room Thermostat down until it fits flush with the wall. Tighten the screws on the underside of the backplate to stop the Room Thermostat being able to fall off the backplate.

Tips for locating the Room Thermostat correctly:

  • At chest height (so it measures the correct temperature).
  • On an internal wall (so it measures the correct temperature and is not affected by being on a cold surface).
  • Not next to any direct sources of heat (so that it measures the temperature of the zone and is not affected immediately by a heat source in the room).