Versions Compared

Old Version 2

changes.mady.by.user April Naoman

Saved on

compared with

New Version 3

changes.mady.by.user Matthew Hart

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Registering your Genius Hub

Your new Genius Hub will need to be registered again on our website , and you via the app.

You will need to choose a new username and password because we cannot have duplicate usernames on the system. We do not know your password, so this can be the same or different to your Genius Hub. For security we recommend choosing a different, secure password.

Transferring Devices to your new Genius Hub

Each device is linked to a single Genius Hub, to communicate with and received commands from. All of your existing devices which are being transferred need to have this link broken, and then added to the new Genius Hub. 

The next step would be to exclude all of the devices before including them in your new hub because this association cannot be transferredeasiest method, is to Factory Reset each of the devices. This can be done physically with the device and does not require either Genius Hub to be powered on or set up.

Here are the instructions on how to Factory Reset common components.

Please see here for all our devices: Factory Reset Devices

* Once they are factory reset you can use the Doctor to add them again, see: Adding New Devices

To create zones and assignments, please see: Zone Setup

Warning

For listening older devices, it is slightly more difficult to exclude remove these and we would recommend sending an email to support@geniushub.co.uk to arrange a call to transfer these over. The new Genius Hub will need to be taken to within 2m of the following devices during the call. This applies to the following devices:

  • Single Channel Receiver
  • Dual Channel Receiver

Transferring Room Names and Schedules

The zones and schedules will need to be created on your new Genius Hub, please see: Zone Setup.

Adding Devices to your new Genius Hub

Once all devices are factory reset, you can use the Doctor to add them to the new Genius Hub, see: Adding New Devices.

During this process you will be able to assign the devices to the zones created above.