In Footprint mode, the system will schedule the heating automatically so you don't have to think about when you use the room. The system will learn when you use the room by the occupancy triggers detected from a Wireless Room Sensor or Wireless Motion Sensor and build the schedule from these triggers. The system will also react to when the room is used, so if you leave the room early or enter the room outside of the predicted schedule the system will also modify the heating accordingly.
...
| Note |
|---|
Footprint mode is only available in Radiator zones with a Wireless Room Sensor or Wireless Motion Sensor assigned to them. Currently the pre-heat feature will not preheat a room for more than 90 minutes, which is fine for a radiator room when it is warming up before it knows that you will be using a room, but not long enough for an UFH room, which may take up to 4 hours to come up to temperature. |
...
| Info |
|---|
|
| Note |
|---|
We recommend that unless you want to user Super-Eco setting, the system is left in Timer mode for at least 1 week so the predictive schedule can start to be built in the background as occupancy is detected. |
...
The relevant settings you may want to adjust are under the header 'Zone reactivity settings' and Pre-heat. For more information see the /wiki/spaces/HGRD/pages/3185084'Setup Pages' chapter.
| Info |
|---|
We recommend that Pre-heat be enabled if you are going to use Footprint mode as otherwise the room will only start to heat at the beginning of each predicted heating period, rather than the room be warm ready for when you normally use the room. |
...