Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Info

The signal travels in straight lines and the only devices that relay the messages are the Smart Plugs, Electric Switches, Powered Thermostats and the Receiver Units. The signal does not bend or bounce, so when positioning think about how thick the wall is that the signal is going to have to pass through to get back to the Genius Hub. Consider that thick stone or concrete walls may be difficult for the wireless signal to penetrate, so the Smart Plug may need to be positioned in a wall socket, which gives a longer route but through thinner walls.

For the Wireless Radiator Valves (DA-WRV-E) see the differences here, the Genius Smart Plug (Dual Band) is the only device which relay the messages, and so should be spread throughout the property between the Genius Hub and any Wireless Radiator Valves.

...

  1. (Preferred) If the Smart Plug is being installed into a 1-Gang, Unswitched Socket:
    1. See a list of compatible single sockets here.
    2. Unscrew the pattress screws holding the socket into the pattress.
    3. Install the Smart Plug and fit the Plug Locking Cover around the Smart Plug, lining up the Plug Locking Cover screw holes with the socket screw holes.
    4. Re-install the pattress screws through both the Plug Locking Cover and socket. This will mean that the Smart Plug can now only be removed by unscrewing the pattress screws.
  2. If using a 2-Gang or Switched Socket, they will likely not have screw holes which line up with the Plug Locking Cover as there is no standard placement for these, and so:

    1. Install the Smart Plug into the socket
    2. Install up to 3 of the adhesive pads provided and fix these onto the flat sections highlighted in grey in the image above. Remove the paper covers from the visible side.
    3. Carefully line up the Plug Locking Cover on the Smart Plug, and firmly push the Plug Locking Cover onto the socket. 

...