Page Comparison

...

1. Follow instructions in the Doctor to include 'Hot Water Time and Temperature addon' onto the system, making a note of the device ID number.
2. To create the Boiler-fed Hot Water Zone:
   1. Go to your 'Hot Water' zone.
   2. Click on the 3 dots, followed by 'Zone Setup'
   3. Remove the Dual Channel Receiver channel from the zone, making a note of the device ID number and channel number.
      Image Added
   4. Delete the 'Hot Water' zone.
   5. Create a new zone of the type 'Hot Water Temperature'.
   6. Add the Dual Channel Receiver channel, removed from the old Hot Water zone, above.
   7. Add in the 'Temperature' channel from the newly assigned device (in step 1).
      
3. If you are also using your Hot Water Time and Temperature addon to control an Immersion Heater:
   1. Create a new zone of the type 'Hot Water Temperature'.
   2. In this zone, click on the 3 dots, followed by 'Zone Setup'
   3. Assign the Hot Water Time and Temperature addon added in Step 1

...