Wireless Room Thermostat (C) Low Battery
- Simon Turner
This article is an excerpt from the Genius Hub Doctor, which is built into the App.
These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.
To access the Doctor, click here
Solution ID: 7706
Step 1
The batteries are low in the Wireless Room Thermostat and they will probably only last for another few weeks before the thermostat stops working altogether.
Gently slide the thermostat up about one centimeter.
Pull the thermostat away from the wall, leaving the backplate attached to the wall.
Step 2
Remove the 2 x AA batteries, (note the orientation of the batteries, one is up and one is down).
Wait 30 seconds before putting in the new batteries.
Step 3
Put in the 2 new AA batteries, (note the orientation of the batteries, one is up and one is down).
Rechargeable batteries should not be used as their voltage is too low (1.2v not 1.5v).
Step 4
Select the Room Thermostat with the flat battery
The Doctor will ask you to select the relevant device
Step 5
The Doctor will communicate with the device
Step 6
Wake up the device by short pressing one of the arrow buttons once.
Step 7
The Doctor will check that the device is configured correctly
Step 8
Replace the thermostat on the wall, starting by locating the thermostat onto the backplate and then sliding it down about one centimeter.
