This article is an excerpt from the Genius Hub Doctor, which is built into the App.

These instructions are provided so that the step-by-step information is available to users, but please note that these actions should generally be carried out whilst using the Doctor.

To access the Doctor, click here

Solution ID: 7000

Step 1

Install the Single Channel Receiver as per the Wiring diagrams and Installation Manual .

To add the device, ideally this is within direct range of the Genius Hub (either in the same room as each other, or adjacent rooms).

If the devices are not close enough together:

1. Move the Genius Hub closer to the Single Channel Receiver. The Genius Hub must have power and an Internet connection. This can be done by:

a) Using a long Ethernet cable
b) Plugging the Hub into a different Ethernet switch
c) Using a Power Line Ethernet adaptor or WiFi booster which has an Ethernet port ( see this link for how to connect the hub with a power-line Ethernet adaptor )

2. Temporarily wire the Single Channel Receiver to a plug and short piece of flex so you can power on the Single Channel Receiver next to the Genius Hub. It is recommended that this is done by an electrician/heating engineer.

Step 2

Now the Genius Hub needs to get ready to add the device.

The Doctor will search for the new device

Step 3

Press & hold the bottom (>||<) button.

The bottom red light stops flashing and the top green light will flash briefly. The 'Off' light turns red when the device has included successfully. If you do not see a green light, release the bottom button after 15 seconds and try to press & hold once again.

On success, the Single Channel Receiver has been assigned a number, write this number on the side of the device.

The Doctor will communicate with the device

Step 4

Now pick a zone to assign the Single Channel Receiver to.

The Doctor will ask you to select a zone

Step 5

The Doctor will create the new zone

Step 6

Putting the device in the selected zone...

The Doctor will now assign the device to a zone

Step 7

This device has now been added to your system.

Browser not supported