Solution ID: 7050

Step 1

Install the Dual Channel Receiver as per the Wiring diagrams .

To add the device, ideally this is within direct range of the Genius Hub (either in the same room as each other, or adjacent rooms).

If the devices are not close enough together:

1. Move the Genius Hub closer to the Dual Channel Receiver. The Genius Hub must have power and an Internet connection. This can be done by:

a) Using a long Ethernet cable
b) Plugging the Hub into a different Ethernet switch
c) Using a Power Line Ethernet adaptor or WiFi booster which has an Ethernet port ( see this link for how to connect the hub with a power-line Ethernet adaptor )

2. Temporarily wire the Dual Channel Receiver to a plug and short piece of flex so you can power on the Dual Channel Receiver next to the Genius Hub. It is recommended that this is done by an electrician/heating engineer.

Step 2

Now the Genius Hub needs to get ready to add the device.

The Doctor will search for the new device

Step 3

Open the cover on the right-hand side of the Dual Channel Receiver to reveal 4 buttons.

Press & hold the 2 white buttons behind the cover.

The red light stops flashing and the top green light will flash briefly. A solid amber light will appear when the device has included successfully. If you do not see an amber light, release the buttons after 15 seconds and try to press & hold once again.

On success, the Dual Channel Receiver has been assigned a number, write this number on the side of the device.

The Doctor will communicate with the device

Step 4

Now pick a zone to assign channel 1 (top button) of the Dual Channel Receiver to.

The Doctor will ask you to select a zone

Step 5

The Doctor will create the new zone

Step 6

The Doctor will now assign the device to a zone

Step 7

Now pick a zone to assign channel 2 (bottom button) of the Dual Channel Receiver to.

The Doctor will ask you to select a zone

Step 8

The Doctor will create the new zone

Step 9

The Doctor will now assign the device to a zone

Step 10